Drive Line Service of Concord
 
HomeFlamming RiverClients & ProjectsDana / SpicerEngineering LinksFeedbackHeavy Metal PolishHow to MeasureLubricationSteel DriveshaftAluminum DriveshaftsMapBMW & MERCEDESDRIVE!event calendar


MEASUREMENT FOR A 2PC DRIVESHAFT IS FROM THE TIP OF THE TRANSMISSION OUTPUT SHAFT OR END YOKE, TO THE CENTER BEARING BOLT HOLE OR SLOT. THEN FROM THE BEARING BOLT HOLE OR SLOT TO THE CENTERLINE OF U-JOINT AT THE DIFFERENTIAL. THIS WILL BE THE FLAT SURFACE WHERE THE U-BOLT HOLE OR STRAP HOLE IS DRILLED.
WE WILL ALSO NEED A MEASUREMENT OF THE OUTPUT SHAFT PROTRUSION FROM THE SEAL OF THE TRANSMISSION.
MEASUREMENT FOR A 1PC DRIVESHAFT IS FROM THE TIP OF THE TRANSMISSION OUTPUT SHAFT TO THE CENTERLINE OF U-JOINT AT THE DIFFERENTIAL. THIS WILL BE THE FLAT SURFACE WHERE THE U-BOLT HOLE OR STRAP HOLE IS DRILLED. WE WILL ALSO NEED THE LENGTH OF THE OUTPUT SHAFT THAT PROTRUDS FROME THE SEAL OF THE TRANSMISSION
 
 
Home | Flamming River | Clients & Projects | Dana / Spicer | Engineering Links | Feedback | Heavy Metal Polish | How to Measure
Lubrication | Steel Driveshaft | Aluminum Driveshafts | Map | BMW & MERCEDES | DRIVE! | event calendar